mainstream tier · Profile refrigeration, laundry, ranges
GE appliance repair in Fort Worth & DFW
GE and GE Profile refrigerators, top-load and front-load washers, dryers, slide-in ranges and dishwashers — we fix the GE appliances Fort Worth households lean on every day.
About GE repair
Why GE owners in DFW call the Cowboys
GE refrigerators, washers, dryers and ranges have been in Texas homes for generations, and the current Profile line is a solid mid-premium choice. We service both older and current GE units — from a top-load washer that will not agitate to a French-door refrigerator with a failed ice maker.
GE has built many generations of the same kind of appliance, so an old top-loader and a new Profile range can share a badge and very little else. We work from the rating plate to confirm which design is in front of us, then test the actual circuit — a valve, a sensor, a board — rather than changing parts out of habit. When a GE refrigerator turns out to need sealed-system work, our EPA-certified technicians take care of the refrigerant.
- Licensed & insured
- Open 24/7
- Same-day service
- 1–2 h emergency response
- EPA-certified refrigerant work
GE appliances we service
What we repair
Built-in refrigeration
French-door · side-by-side · top- and bottom-freezer · Profile models · ice makers and dispensers
Washers & dryers
Agitator and impeller top-loaders · front-load washers · electric and gas dryers · Profile laundry
Pro ranges & cooktops
Freestanding and slide-in ranges · Profile ranges · gas, electric and induction models
Dishwashers & DishDrawers
Built-in GE and Profile dishwashers · top-control and front-control models
Common GE faults
Symptoms we see most
- Top-load washer fills but won't agitate
- Water dispenser slow or not working at all
- Freezer fine but the fridge section is warm
- Dryer takes two or three cycles to dry
- Surface burner clicks but won't light
- Plastics and cups come out of the dishwasher wet
Typical GE repairs
- Refrigerator cooling, ice maker and water-valve repairs
- Washer drive, pump and control faults
- Dryer heating and vent-related issues
- Gas range igniters, bake elements and oven sensors
How it works
Three steps to a working GE
- 01
Call or book online
Reach a real dispatcher 24/7 at (469) 333-1806, or pick a slot online. Tell us the brand and model — we bring the right parts.
- 02
Diagnose on site
A licensed, insured technician arrives in a marked polo with floor protection, runs a full diagnostic and explains the fix and the price before touching a screw.
- 03
Repair, test, warranty
Most repairs finish the same visit. We test-cycle the appliance, clean up, and stand behind the work.
Service area
Where we repair GE
Within roughly 35 miles of Fort Worth. Cities marked “call to confirm” are on the outer edge of the radius.
- Fort WorthTarrant County
- KellerTarrant County
- SouthlakeTarrant County
- ColleyvilleTarrant County
- GrapevineTarrant County
- HasletTarrant County
- SaginawTarrant County
- Blue MoundTarrant County
- North Richland HillsTarrant County
- Richland HillsTarrant County
- Haltom CityTarrant County
- HurstTarrant County
- EulessTarrant County
- BedfordTarrant County
- ArlingtonTarrant County
- Grand PrairieDallas County
- IrvingDallas County
- White SettlementTarrant County
- River OaksTarrant County
- DallasCall to confirm
- Highland ParkCall to confirm
- University ParkCall to confirm
- CoppellCall to confirm
- Flower MoundCall to confirm
- LewisvilleCall to confirm
- PlanoCall to confirm
- FriscoCall to confirm
FAQ
GE repair — common questions
My GE freezer is cold but the fresh-food side is warm — what usually fails?
On GE refrigerators that pattern usually points to airflow: a stalled evaporator fan, an evaporator iced up after a defrost heater or thermostat failure, or a damper stuck shut between the compartments. The compressor is often fine. We check each in turn and melt off any frost so cooling recovers once the failed part is replaced.
How do you tell an older GE apart from a current Profile unit?
The rating plate lists the model and serial, which tells us the product family and roughly when the appliance was built. That matters on GE, because parts and wiring changed a great deal between generations. We read it at the start of the visit so the diagnosis follows the right wiring diagram from the outset.
Do you repair GE appliances built since Haier bought GE Appliances?
Yes. The GE and GE Profile names carried on after the 2016 sale, and newer units are repaired the same way as any other: we test the system that failed, source the correct part for that model and explain the job in plain terms. GE-branded appliances from before the sale are just as welcome.
Also serviced
Other mainstream brands we repair
All 21 brands · Independent service company — not affiliated with the manufacturers listed.
Ready when you are
Book GE repair today
Decades-old GE top-loader or a Profile range bought last year — ring us, describe what it's doing, and we'll book a technician who knows that generation.
Open 24/7 · Monday – Sunday
10501 Winding Passage Way, Fort Worth, TX 76131